Gardman Elegance Wooden Arch - Manual

Wooden Arch
Assembly Instructions
Tools Required (not supplied)
• 10mm spanner
(adjustable spanner or large pliers
will suffice)
• Phillips screwdriver
Before You Start
• Lay out all of the component parts and
make sure you have all of those listed.
• When you are ready to start, make sure
that you have the right tools to hand,
plenty of space and a clean dry area for
assembly. Always try to assemble the
product as close as possible to the
intended location.
• Remove all plastic bags and dispose of
them safely.
• Retain the instructions for future use.
Caution
This pack contains small items which should
be kept away from children.
Consumer Helpline
If you have any problems or queries with this
product then please contact our
helpline number: 01406 372227, or fax
+44 (0) 1406 372233.
Or write to: Gardman Ltd. High Street,
Moulton, Spalding, Lincs, PE12 6QD.
H
D
E
A
J
C B
F
G
Ref Qty Description
A 2 Left handed long legs
B 2 Right handed long legs
C 2 Trellis panels
D 4 Rebated cross bars
E 4 Plain cross bars
F 2 Left handed curved members
G 2 Right handed curved members
H 8 6mm - 85mm Allen bolts
I 8 6mm - 50mm bolts
J 8 6mm - 50mm bolts, nut and washer sets
K 1 Allen key
K
I
1 Connect a left handed long leg (A), a right handed
long leg (B) and 2 rebated cross bars (D) with 4 x
85mm Allen bolts (H), using Allen key (K) provided.
Leave the bolts loose at first then expand a trellis
panel (C) and fit within the frame, positioning the
edges of the trellis panel into the inner rebated
grooves on the long legs and cross bars. Once in
place, tighten the bolts fully to secure each frame
side. Repeat to make the second side section.
2 Take one left hand curved member (F) & join to one
right hand curved member (G) with two of the
50mm bolts, washers & nuts (J). Repeat to make
second top arch side. Insert 4 x 6mm bolts (I)
through the holes in side of the one top arch side
& into the ends of the 4 plain cross bars. Ensure
the top arch side has the rebated ends facing
inwards toward the plain cross bars. Tighten with
Allen key. Then place second top arch side on the
other ends of the plain cross bars & insert four more
6mm bolts (I) and tighten with Allen key. This forms
the roof assembly.
3 Take one side section and slot into the roof assembly
as shown & secure with two 6mm bolts with washers
and nuts (J). Repeat with second side section at
other end to form the entire arch assembly. Once
completed and all bolts are well tightened the unit
can be lifted up-right and installed into the intended
permanent position by sinking the legs into earth
or concrete filled trenches. Alternatively use
Gardman Ground Spikes (set of four) available
separately - product code 07715.
Assembly