ETC Source Four Mini Canopy and Track Mount - Manual (Page 2)

E T C I n s t a l l a t i o n G u i d e
Source Four Mini
Source Four Mini Canopy and Track Page 2 of 2 Electronic Theatre Controls, Inc.
Step 6: Using the canopy screws, secure the fixture to the mounting plate,
while keeping in mind the alignment in Step 5.
Step 7: Open all of the shutter blades
by sliding them outward until
they stop.
Step 8: Install gobo and/or gel as
desired and confirm that they
are properly secured.
Step 9: Restore power at the main
fuse.
Step 10: Focus the fixture as desired.
Track Installation Procedure
Step 1: Insert the track adapter
into the track. The
adapter will only fit one
way into the track with the
tabs of the adapter in the
groove of the track.
Step 2: Lock the adapter into
place.
Step 3: Select circuit 1 or 2 using
the circuit selection wheel.
Step 4: Focus the fixture.
Step 5: Lock the fixture into place using the yoke lock.
WARNING: To reduce the risk of fire and electric shock, use only with
EUTRAC track system.
A V E R T I R : Réduire le risque de feu et la décharge électrique, l'usage
seulement avec le systéme de piste d'EUTRAC.
Canopy Canopy
Yoke Stop Bracket Yoke Stop Bracket
Ground Wire Ground Wire
Mounting Plate Mounting Plate
Lock Lock
Tabs Tabs
Circuit Circuit
Selection
Selection
Wheel
Wheel
There are posts on both the yoke
lock and the yoke that will prevent
the fixture from rotating all the
way around to protect the cable.
The yoke can be locked into
place using a 1.5mm Allen
Wrench.