ETC Source Four CE HID PAR - Manual (Page 7)

English
Source Four HID PAR CE 7
Installing a lens
1.
Disconnect power to the fixture before handling.
2.
Position the fixture with the front of the unit (the lens side) facing you, and tilted slightly (
Figure 2
).
3.
Position the lens rotation ring with the spring clip at the top of the fixture, directly below the color frame
retaining clip.
4.
Hold the lens by the edge, and position it so the convex side faces the back of the fixture (
Figure 4
).
5.
From the top of the fixture, slide the lens behind the lens catchers and position its base behind the tabs on the
bottom of the lens rotation ring.
6.
Gently push the top of the lens inward until it snaps behind the spring clip.
Colour frame retaining clip usage
The colour frame holder is equipped with a spring-loaded retaining clip that prevents colour frames and accesso-
ries from falling out. Make sure the Source Four HID PAR CE has the colour frame retaining clip in the locked
position when hanging.
N o t e :
Make sure to use colourframes or accessories with a 17 cm inside diameter.
1.
Release the retaining clip by pushing it sideways. The retaining clip opens.
2.
Insert the colour frame.
3.
Press the retaining clip down until it locks.
Cleaning the reflector
1.
Unplug the fixture before attempting to clean the reflector.
2. Remove the lamp before attempting to clean the reflector.
3.
Remove the lens so you can access the reflector from the front of the fixture. (See
Removing a lens
on page 6)
4.
Remove dust with a blast of oil free air, or wipe with a clean, soft, lint-free cotton cloth. If this is sufficient to
remove dust, go to step 7. Otherwise, continue to step 5.
5. Dampen a clean, soft, lint-free cotton cloth with a mild, soapy water solution and gently wipe the reflector.
6.
Remove any soapy water residue with a clean, soft, lint-free cotton cloth dampened with water.
7. Reinstall a lens before using the fixture.
C A U T I O N : Do not use glass or window cleaners on the reflector. Chemicals in the cleaners
will harm the reflective coating. Do not use paper towels or harsh materials to wipe
the reflector. These materials can scratch the surface of the reflector.
Figure 4
Spring clip
Retaining clip
Tab
Figure 5
Retaining clip in
the locked position