ETC Source Four XT HID Zoom Pole Mount - Manual (Page 2)

11.1 inch
(282mm)
9.25 inch
(235mm)
Front view Side view
30.86 inch
(784mm)
13.11 inch
(333mm)
Rear view
10.4 inch
(264mm)
7.5 inch
(191mm)
13.0 inch
(330mm)
11.1 inch
(282mm)
9.25 inch
(235mm)
Front view Side view
24.42inch
(620mm)
13.11 inch
(333mm)
Rear view
10.4 inch
(264mm)
7.5 inch
(191mm)
13.0 inch
(330mm)
Fixture Dimensions
Standard yoke shown.
Page 2 of 2
To install the pole mount:
Step 1: Bolt the fixture or fixtures to the mount with one or three provided bolts
through the holes in the base of yoke.
Step 2: Route the power cable or cables through the cable grip or grips and pull to the
supply cable. Leave slack in the cable between the fixture and the cable grip
to allow aiming the fixture.
Step 3: Tighten the cable grip.
Step 4: Make the electrical connection to the supply cable inside the pole.
Step 5: Place the pole mount and fixture assembly onto the pole.
Step 6: Aim the fixture or fixtures.
Step 7: Tighten the four hex screws to secure the pole mount to the pole.
Single Fixture Pole Mount Twin Fixture Pole Mount
10.25 inch
(260mm)
4.25 inch
(108mm)
(inside)
7.25 inch
(184mm)
4.1 inch
(104mm)
25.0 inch
(635mm)
5.0 inch
(127mm)
4.1 inch
(104mm)
4.25 inch
(108mm)
(inside)
25-50
15-30