Brother P-touch RL-700S - Manual (Page 13)

13
Before using your machine
Description of buttons
Lamp display
The ON/OFF button lamp (blue) and Error lamp (red) indicate the current operating status.
Button Function
ON/OFF button ( ) Turns the printer on and off.
Feed and Cut button ( )
Feeds and cuts the printed labels.
Use this button when the auto cut option in the printing dialog
box is not checked.
* Feed and cut does not function when SZ tapes are
loaded.
Open Cover button Opens the cover.
Lamp Status
Printer Status
ON/OFF
Button (Blue)
Error Lamp
(Red)
Off Off • The printer is off.
On Off • The printer is working normally.
Flashing Off • The printer is receiving data from the computer.
Flashing On
• The printer is receiving data from the computer, but unable
to print.
Load a tape cassette and close the cover.
On On
• No tape cassette is loaded, or the cover is open.
Load a tape cassette and close the cover.
• The Feed and Cut button was pressed when SZ tape is
loaded. (Unable to use the Feed and Cut button when SZ
tape is loaded.)
• You reached the end of the SZ tape. Remove the SZ tape
cassette and check the surface of the tape. If "END" is
printed on the tape, replace the cassette with a new SZ
tape cassette.
On Flashing
• A print job is received, but the printer cannot print. Load the
correct tape cassette and close the cover.
• If ERROR is printed on the SZ tape, an error occurred
when writing data to the RFID tag or the tag is damaged.
Try printing again.
On
Flashing
Rapidly
• Make sure that the tapes are not jammed in the printer.
Turn the printer off and on.
* If the problem is not solved, contact your dealer or
authorized service center.
On
Flashing Very
Rapidly
• Turn off the printer, and then turn it on again.
* If the problem is not solved, contact your dealer or
authorized service center.