Brother P-touch RL-700S - Manual (Page 10)

Before using your machine
10
• Data reading may be significantly impaired if labels are applied directly to moist surfaces or
near them. Test operation before applying labels to surfaces.
• Do not bring SZ tape cassettes or RFID tags within 50 mm in front of, above, or on the right
side of the printer when it is in use. This may interfere data writing during printing.
• Do not bring SZ tape cassettes within the read range of other RFID reader/writers. This may
interfere data writing during printing.
• To avoid damaging labels, do not bundle the tape, put objects on it, or scratch it using hard
objects. Do not apply labels to objects where they will be subjected to strong vibration or
impact.
• Check where you will apply labels before applying them.
Once labels are applied, you cannot reapply them elsewhere after peeling them off.
• Do not attempt to disassemble the cassettes or labels.
• Depending on environmental conditions and the location and material of objects labelled,
labels may peel away, become irremovable, or leave a residue. Also, the label color may
change over time, and the surface underneath may be damaged.
• Do not apply labels to skin.
• Before setting the casette, take up any slack in the ribbon by winding it in the direction shown
1 - 2 times around.
• Note that the margin of the first label printed is larger than other labels.
• To avoid label damage or data loss, do not use labels in extremely high or low temperatures.
• Note that applying labels to curved surfaces will lower the read rate because the antenna will
be curved. Extremely curved surfaces may interfere reading, and the tape may peel off.
• Do not bend labels, which may break the antenna or damage the RFID tag.
• To avoid fire, do not put labels in microwave ovens.
• This product uses I-Code SLI RFID chips manufactured by NXP Semiconductors.
These chips are compatible with reader/writers conforming to ISO/IEC 15693 and 18000-3
standards. (Operation is not guaranteed with all reader/writers.)
• When introducing a system based on SZ tape labels, check the environment of use carefully
to ensure correct operation before use.
• When tape or labels are no longer needed, cut the RFID tag portion or take other measures
to interfere data reading or writing before disposal.