Warnings, Cautions, Ce marking conformance – ElmoMC Gold Line Digital Servo Drives-Gold Tuba User Manual
Page 7: Warranty information
Gold Tuba Installation Guide
MAN-G-TUBIG-EC (Ver. 1.201)
7
2.1. Warnings
•
To avoid electric arcing and hazards to personnel and electrical contacts, never
connect/disconnect the servo drive while the power source is on.
•
Power cables can carry a high voltage, even when the motor is not in motion. Disconnect
the Gold Tuba from all voltage sources before servicing.
•
The high voltage products within the Gold Line range contain grounding conduits for electric
current protection. Any disruption to these conduits may cause the instrument to become
hot (live) and dangerous.
•
After shutting off the power and removing the power source from your equipment, wait at
least 1 minute before touching or disconnecting parts of the equipment that are normally
loaded with electrical charges (such as capacitors or contacts). Measuring the electrical
contact points with a meter, before touching the equipment, is recommended.
2.2. Cautions
•
The maximum AC power supply connected to the instrument must comply with the
parameters outlined in this guide.
•
When connecting the Gold Tuba to an approved isolated auxiliary power supply, connect it
through a line that is separated from hazardous live voltages using reinforced or double
insulation in accordance with approved safety standards.
•
Before switching on the Gold Tuba, verify that all safety precautions have been observed
and that the installation procedures in this manual have been followed.
•
Make sure that the Safe Torque Off is operational
2.3. CE Marking Conformance
The Gold Tuba is intended for incorporation in a machine or end product. The actual end product
must comply with all safety aspects of the relevant requirements of the European Safety of
Machinery Directive 2006/42/EC as amended, and with those of the most recent versions of
standards EN 60204-1 and
EN ISO 12100
at the least, and in accordance with
2006/95/EC.
Concerning electrical equipment designed for use within certain voltage limits, the Gold Tuba meets
the provisions outlined in 2006/95/EC. The party responsible for ensuring that the equipment
meets the limits required by EMC regulations is the manufacturer of the end product.
2.4. Warranty Information
The products covered in this manual are warranted to be free of defects in material and
workmanship and conform to the specifications stated either within this document or in the
product catalog description. All Elmo drives are warranted for a period of 12 months from the time
of installation, or 18 months from time of shipment, whichever comes first. No other warranties,
expressed or implied — and including a warranty of merchantability and fitness for a particular
purpose — extend beyond this warranty.