Elkhart Brass Stinger RF8297 - Manual (Page 16)

13
81327111 Panel Mount Transmitter
a) Mark the panel cutout and mounting screw pattern per dimensions in Figure 13
b) Cut a rectangular clearance opening and drill four
 0.219” (7/32” drill) holes.
c) Insert fixed transmitter case through panel cutout. Secure the unit to the panel
with four #10-32 screws. The length of the screws should be the panel thickness
plus 3/16”. The screws supplied are ¼” long. Apply Loctite #242 to the threads
of the screws before tightening them.
d) The transmitters antenna is to be mounted using the 10 foot antenna cable
provided to locate one of the antennas outside the vehicle compartment in a
position that provides the least obstructed line of sight to the monitor’s antenna.
e) Place a 1A fuse between the red lead of the transmitter and a switched positive
power lead on the vehicle. Attach the black lead from the monitor base to the
vehicle ground.
f) All control functions are sent to the monitor via an encoded RF signal from the
transmitter.
Figure 13
Panel Mount Transmitter Mounting Template