ECOXGEAR IRMS300: MicroSystem User Manual
Page 15
15
Network OK
IF the screen displays either WEP or WPA, a password is required:
Enter WEP key
OR
Enter WPA key
Then the network is using one of the encryption systems: Wired Equivalent Privacy (WEP) or WiFi
Protected Access (WPA or WPA2). You therefore need to enter the correct WEP or WPA password on
your MICRO SYSTEM radio to communicate with your network.
Only the person who set up the network in the first place knows this password; if that person is not you
then you need to find out the password. You can do this by checking with the Customer Service of your
internet provider or the manufacturer of your wireless router.
After approximately 3 seconds, the display goes into the password entry mode:
█
To enter the password, use the SCROLL KNOB or the UP/DOWN buttons to select each
letter/number/symbol of the password in turn, pressing OK after each letter.
NOTE: WEP and WPA passwords are upper and lower case sensitive and MUST be entered exactly
HINT: Use the ‟Back‟ button to erase incorrect characters as you may have entered.
IF the display shows: “Invalid key” or “Network Error”, an incorrect password has probably been entered.
After entering the final letter/number/symbol, scroll to find and select END and press OK.
Once the password is entered correctly, your MICRO SYSTEM should now be able to connect to the
network.
Your radio should now be able to connect to the selected network without having to re-enter a
password. Your password will be saved in your Grace radio even if a power outage occurs. You will
have to alter your password however, should you attempt to connect to an alternative wireless network