Query the operating state of the heater, Permanently change the operating time, For adjustment – Eberspacher EasyStart Remote User Manual
Page 10: Ting time (see, 3 operation and setting/adjustment
10 | VehiCLe heATeRs – TeChniCAL DOCuMenTATiOn
3 OpeRATiOn AnD seTTing/ADjusTMenT
permanently change the Operating time
keep the
button pressed until “CuRRenT
OpeRATing TiMe WiLL be DispLAyeD As
FLAshing” appears.
please nOte!
A switched on heater is switched off with this
setting.
Data transmission
LeD: lights up green
LeD: flashes red for
8 seconds
Data transmission
LeD: lights up green
Current operating
time is indicated
by flashing, e.g. 3x
red for 30 minutes
operating time.
Release the
button; further flashing sig-
nals follow for the selection of the operating
time (
).
Query the Operating state Of the
heater
press the
button, the connection is set up
with the stationary unit is.
Data transmission
LeD: lights up green
The following indications are possible:
if the heater is On
LeD: flashes 5x
green
if the heater is OFF heater is switched on
LeD: flashes 12x
green
if heating mode or ventilation mode is not
required, press the
button; the heater is
switched off.
please nOte!
possible LeD indications such as alternat-
ing red-green flashing, red flashing or con-
tinuously lit red are described in the chapter
“What to do if …?”