Doug Fleenor Design PRE10-P - Manual (Page 3)

Page 3 of 6
SETUP AND CONNECTIONS
The Preset 10 Portable should be installed between the console and DM X512 receiving devices. Typically, it should be
within arm s length of the console operator.
Rem ove the cable connected to the output of the console. Use a short DMX512 cable to connect the output of the console
to the DM X512 input of the Preset 10 Portable. Connect the cable that was originally connected to the console to the
DMX512 output connector of the Preset 10 Portable. This inserts the Preset 10 Portable into the DM X512 signal path.
Plug the Preset 10 Portable power supply into m ains power.
NOTE:
!
The console will still operate norm ally when the Preset 10 Portable is not powered.
OPERATION
INDICATORS
RED LED
ON = RECEIVING DMX512
FLASHING = RECORD MODE
GREEN LED
ON = CURRENTLY SELECTED PRESET
FLASHING = TIME SETTING MODE SELECTED FO R THAT PRESET
ALL GREEN LEDS
FLASHING = LO SS OF DMX512 INPUT ALERT - PRESET 10 PORTABLE
IS HO LDING THE LAST LOOK.
GREEN LED RED LED STATE
OFF OFF UNIT NOT POW ERED
OFF ON
RECEIVING DMX512
PRESET PLAYBACK IS LOCKED OUT
OFF FLASHING
RECO RD MODE ACTIVE
CURRENT LOOK W ILL BE STO RED TO NEXT PRESSED PRESET
FLASHING OFF TIME SETTING MODE ACTIVE FOR SELECTED PRESET
ON OFF
PRESET 10 PO RTABLE TRANSMITTING DMX512
NO DMX512 INPUT
W hen the prim ary console is powered ON your lighting system should function norm ally. The RED LED of the Preset 10
Portable will illum inate indicating that a DMX512 signal is present.