DIGIWEIGH DWP-10000F Series - Manual (Page 8)

7
Configuration
The indicator contains two main setup menus: The Setup (“H”) menu, which configures
the indicator to your weigh platform and the User (“A”) menu, which configures the
serial communication port and enables some user options. The Setup and User menus
consist of several menu selections, each with its own sub-menu of choices.
To set up the indicator, you must first enter the appropriate menu mode. Once there,
four of the front panel keys become directional navigators to move around in the menus,
and one key is used to save or SET the selections.
Set up H menu
1. Power off the indicator.
2. On the rear panel move the Calibration/Setup Switch to the opposite position.
3. Power on the indicator. The indicator shows ” H 1” to indicate that you are in Setup
H menu mode.
Use the directional keys to move around in the Setup Menu Chart.
1. To move to a new “H” heading, use the TARE (left) or PRINT (right) key to move right
or left in the Setup Menu Chart.
2. To move to the selection level, press the ZERO (down) key once. The current saved
selection is shown.
3. To view the available selections for the current “H” heading, use the TARE (left) or
PRINT (right) key to move through the selection field.
4. To save a new selection, press the NET/GROSS (Set) key .To exit without saving,
press the UNITS (up) key to return to the current “H” heading.
5. Repeat Steps 1 through 4 until the Setup Menu is programmed.