Despatch LAC2-12-5 - Manual (Page 65)

56
16. Replace and fasten the fan inlet cover.
17.
Adjust the fan wheel for 3/16 inch clearance between the wheel and the inlet ring
and tighten the set screws on the fan wheel. Check that the set screws hit the
flats machined into the motor shaft.
18.
Replace and fasten heater.
19.
Replace fan and heater plug assembly in oven body.
20.
Replace left side wall.
21.
Replace and fasten floor plate.
22.
Replace fresh air damper arm assembly.
23.
Replace fresh air damper handle.
24.
Connect heater leads to circuit board.
25.
Connect motor wire harness and fasten motor and heater ground wires to ground
stud.
26.
Connect thermocouple wires to control.
27.
Replace control panel in oven body.