Despatch LAC2-12-5 - Manual (Page 49)

40
Enable Page
The Enable Page controls access to the other Setup Pages. The setpoint minimum and
maximum values, and the security passwords are also set on the Enable Page.
To access the Enable Page, enter the Setup Mode using a level 2 access code (see
description earlier in this manual). Press the Page key until Enable is displayed. Press
the Menu key. Each parameter can be changed by pressing the Menu key until the
desired parameter is displayed, and then pressing the
keys to change the value.
NOTE: Changing the enable
to “yes” for each page will allow access to the page in
Level 1 security.
Menu Item Display Description Range
Profiles Enable Profile
1-8 Controls access to Program Page Yes or No
Autostart Enable Auto
Start Controls access to AutoStart
Page Yes or No
PID Enable PID Controls access to PID Page Yes or No
Control Enable Control Controls access to Control Page Yes or No
Communication Enable
Communication
Controls access to
Communication Page Yes or No
Real Time
Clock Enable Clock Controls access to Real Time
Clock Page Yes or No
Relay outputs Enable Relay
1-4 Controls access to Relay Page Yes or No
Test Enable Test Controls access to Test Page Yes or No
Zone
Calibration Enable Zone
Cal Controls access to Zone
Calibration Page Yes or No
Sensor
Calibration Enable Sensor
Cal Controls access to Sensor
Calibration Page Yes or No
Setpoint lower
limit Enable
SPLowerLim Sets minimum setpoint allowed -73°C to 760°C (-100°F to 1400°F)
Setpoint upper
limit Enable
SPUpperLim Sets maximum setpoint allowed -73°C to 760°C (-100°F to 1400°F)
High limit
overhead Enable
HiLimOH Sets maximum high limit setpoint
allowed* 3 to 11°C (5 to 20°F)*
Password level
1 Enable
Password 1 Sets password for access level 1 0 to 1000
Password level
2 Enable
Password 2 Sets password for access level 2 0 to 1000
Setpoint
Change Enable
SPChange Set to DISABLE to lock out
setpoint and high limit setpoint
changes in Manual and Timer
Modes Yes or No
Analog Output
Type Enable Analog
Type Sets Analog Output type Ctrl or Proc
* Maximum high limit setpoint = SPUpperLim + HiLimOH