Despatch MIC1462 Controller Quick Start - Manual (Page 8)

6
indicator will go on continuously. When the operator removes the manual Hold (by
pressing the RUN/HOLD key again), the HLD indicator will either flash (indicating that
the Deviation-Hold conditions still prevail) or go off (indicating that the Deviation-Hold
conditions no longer prevail).
RUN INDICATOR FLASHING: This indicates that the program is in a Delay state (i.e. is
timed to start after a user-defined delay has elapsed). When the delay period has
elapsed, the program will run and the RUN indicator will come on continuously.
Aborting A Program
The operator may abort (i.e. terminate) the current program by holding down the
RUN/HOLD key for more than five seconds. When the program is aborted, a return is
made to the Base Mode and the Message area will read Aborted.
This message will be removed by the next key press.
"End Of Program" Indication
When the program has completed its End Segment (i.e. the last segment to
be performed), the message display will read At End, and a return is made to the Base
Mode. Press any key to clear the Message Display.