Despatch MIC1462 Controller Quick Start User Manual

Page 12

STEP

DESCRIPTION MESSAGE

DISPLAY

FUNCTION

AVAILABLE SETTING

Start Time

Strt-ti

Determines the automatic
start time for the profile

1:00 - 24:59
OFF = manual start only

Start Day

Strtday

Determines the day of the
week when start time
applies

ALL = 7 days a week
Mon = Monday
tuE = Tuesday
Wed = Wednesday
thu = Thursday
Fri = Friday
SAt = Saturday
Sun = Sunday
5 dy = Mon - Fri
6 dy = Mon - Sat

* Not displayed if deviation hold is off.
** Only displayed when real-time clock is fitted, or if timer is set to On.

Editing/Viewing Parameters In Any/Each Segment In A Specific Program
(Program Number = 1 to 8, Segment Number = 1-16)

Adjust the Program Number (using the PROF key) and the Segment Number (using the
RUN/HOLD key) as required. The parameters presented will be these relevant to the program
and segment whose numbers are displayed. The parameters sequence for each segment is as
follows. Press the SCROLL key to step through each parameter.

Segment Programming

1. After all the program parameters are set for a particular program number, be sure the

desired program # is still displayed and then press the Run/Hold key. A one should now
be displayed in the segment # display.

2. The segment programming parameters will now be displayed in the message display and

the setting will be displayed in the lower display.

3. Press the up or down arrow to change the values in the lower display, press the scroll

key to go to the next parameter in the message display. Not ethe program number and
segment number displayes will remind you which program and step you are currently
programming.

4. To get 4 dashes “----“ on the display for the final SP, press the up and down arrow at the

same time.

5. To enter “End” into the time for the final segment, press down arrow to go below 0.