Dascom TallyCom III Set-up Guide for IBM System i/iSeries/AS400 in TCP/IP environments - Manual (Page 5)

DASCOM AS/400 Set-up Guide Version 2.0 Page 5 of 10
3. AFP/IPDS (PSF) printing using TCP/IP
This chapter provides configuration guidelines for OS/400 version 3.7 or higher. The
versions may differ somewhat in the setup.
Requirements:
Before IPDS printing using TCP/IP can be accomplished, the following points need to be
checked:
TGNet print server with IPDS capability
TCP/IP is installed and enabled
The relevant PTFs are applied
Details on how to verify these items can be found on the internet.
Consult the following IBM web address for details:
www.ibm.com/systems/support/i/
Recommended IBM documentations are:
IBM Doc. No. 8414724, PTF Listing for AFP Printing
IBM Doc. No. 8203740, PTF Listing for TCP/LAN Printing
Note: Default IPDS port of the TGNet is: 5001
3.1 AS/400 Settings for Version 3.7 or higher
To configure IPDS printing on OS/400 V3R7, you must use two commands:
CRTDEVPRT
CRTPSFCFG
3.3 Configuring PSF with CRTDEVPRT
At the AS/400 command line, enter a command in the form:
CRTDEVPRT DEVD() DEVCLS(*LAN) TYPE(*IPDS)
MODEL(0) LANATTACH(*IP) AFP(*YES) PORT(5001)
FONT(11) FORMFEED(*CONT) RMTLOCNAME(‘172.20.70.21’)
USRDFNOBJ(AFP/NETWRKPRT *PSFCFG)
TEXT('Print server description')