Dascom T2280+2T Quick Start Guide - Manual (Page 27)

➤
Selecting character
density and font You can use the CPI (= Characters Per Inch) key in setup mode to select the number of characters
per inch to be printed. You can use the Font key to select resident fonts.
Press the Setup key, then the Char (4) key.
Press the CPI (3) or Font (2) key (in our example, press CPI).
Use the < (2) or > (3) key to set the desired character density. Confirm the se-
lection by pressing the Set (1) key.
You can cancel the selection and leave the setting unchanged by pressing the
Exit (4) key.
If you pressed the Font (2) key, use the < (2) or > (3) key to select the desired
font. Confirm the selection by pressing the Set key.
You can cancel the selection and leave the setting unchanged by pressing the
Exit (4) key.
Press the Setup key. The printer returns to the initial status. It is also possible
to press the Online key. The printer then changes directly to online mode.
Adjust Paperway
Menu Char Online
Setup
2 1 3 4
Font CPI
Online
Setup
2 1 3 4
10 CPI *
Set < > Exit Online
Setup
2 1 3 4
ROMAN NLQ
Set < > Exit Online
Setup
2 1 3 4
Adjust Paperway
Menu Char Online
Setup
2 1 3 4
The selection made will not be retained after switching off the
printer. For more details on how to set the character density perma-
nently, please refer to the User Guide on the Online CD-ROM.
ENGLISH
Quick start guide Settings
25