Dascom T2280+2T Quick Start Guide - Manual (Page 26)

Confirm the input by pressing the Set (1) key.
Press the Setup key. The printer returns to the initial status.
➤
Setting the print
head gap The printer features automatic print head gap adjustment to the thickness of the paper used. In
setup mode, you can enter a correction value to modify the head gap that is normally determined
automatically. This correction is useful for modifying the appearance of the type face and the
impact force for multi-layer paper.
The AGA (automatic gap adjustment) function must be set to On. For more detailed informa-
tion, refer to the User Guide on the Online CD-ROM.
Press the Setup key. The printer changes to setup mode.
Press the Adjust (2) key.
Press the Head (1) key.
Use the < (2) or > (3) key to set the range within which the automatic gap
adjustment is to be corrected. You can select values in the range from -10 to +10.
Confirm the input by pressing the Set (1) key.
Press the Setup key. The printer returns to the initial status.
Negative values decrease the print head gap, positive values increase it.
The setting made will be retained after switching off the printer.
FormAdj= 17/72"
Set < > Exit Online
Setup
2 1 3 4
The setting made will be retained after switching off the printer.
For more details, please refer to the User Guide on the Online
CD-ROM.
Adjust Paperway
Menu Char Online
Setup
2 1 3 4
TOF
Head Tear Online
Setup
2 1 3 4
Head= 0 *
Set < > Exit Online
Setup
2 1 3 4
Settings Quick start guide
24