Dascom 1325 User Guide - Manual (Page 48)

Tally Dascom 1325
34
Adjust Physical Margins
Adjust Page Margins allows for adjustments of physical left, top margins and tear-off position. Warning: Once
these settings are changed, resetting the printer to factory defaults will not initialize these settings back to the
original settings; so it is not advisable to perform this adjustment unless it is absolutely necessary.
Adjust Top Margin Procedure:
1. Enter the Adjust Page Margins function by holding down the【Load/Eject】and【Online】keys while
powering up until the printer beeps twice.
2. Load
paper.
3. The printer will print as below:
Adjust Page Margins:
【
LF/FF】=OK 【Tear/Off】= Back 【Load/Eject】= Next 【Online】= Exit
Current Setting: Adjust Fanfold Top Margin
Press【LF/FF】key to confirm selection if the paper used is fanfold type. The printer will print as follows:
Procedure：
Install fanfold paper to tractors
【
LF/FF】 = Add 【Load/Eject】 = Reduce 【Online】 = Exit
Each step is 0.5 mm
Function of keys:
【
Tear Off】key: Decrease 0.5mm
【 Load/Eject】key: Increase 0.5mm
4. Press 【LF/FF】 key, printer will print “Save settings？Yes”. Press 【Load/Eject】 key to choose
Yes or No，then press 【LF/FF】 key to confirm selection and exit “Adjust Page Margins” mode by
pressing 【Online】. The print head moves to the left side and the printer beeps twice, then the print
head moves to the middle position.
Adjust Left Margin Procedure:
1. Enter the Adjust Page Margins function by holding down the【Load/Eject】and【Online】keys while
powering up until the printer beeps twice.
2. Load
paper.
3. The printer will print as below:
Adjust Page Margins:
【
LF/FF】=OK 【Tear/Off】= Back 【Load/Eject】= Next 【Online】= Exit
Current Setting: Adjust Fanfold Top Margin
4. Press【Load/Eject】key until the current setting is “Adjust Fanfold Left Margin”. Press【LF/FF】key to
confirm selection if the paper used is fanfold type. The printer will print as follows:
Adjust Fanfold Left Margin 0
Function of keys:
【
Tear Off】key: Decrease 0.5mm