Danuser 9000 Postmaster/SlabBlaster - Manual (Page 9)

9
STEP 7: Ensure the safety catch is in place. The safety catch prevents the hammer from
sliding out of the Postmaster/Slab Blaster.
STEP 8: Raise the Postmaster/Slab Blaster in the air, and tilt it forward 90°. Watch for any
obstructions or pinching of hydraulic hoses.
STEP 9: Shut off the vehicle engine.
STEP 10: Grease the exposed hammer rails.
STEP 11: Again ensure the safety catch is in place, and pull the hammer out towards you
until it hits the safety catch. Grease the rest of the hammer rails, and oil the chain
drive.
STEP 12: Set the hydraulic flow control at 3.
Do not operate the Postmaster/Slab Blaster without first
setting the flow control. Serious damage to the drive
assembly may occur.
Assembly &
Installation
(continued)
C A U T I O N
Always reinstall the transit bolt before transporting or
shipping the Postmaster/Slab Blaster. This bolt prevents
the hammer from sliding during transport or shipping.
Do not tilt or operate the Postmaster/Slab Blaster without
the safety catch in place. The hammer could slide out of
the Postmaster/Slab Blaster and cause serious injury or
death.
w A R N I N G
C A U T I O N
Transit Bolt
Safety Catch
Flow
Control