Danuser 9000 Postmaster/SlabBlaster - Manual (Page 24)

2
STEP 6: Start the vehicle, and slowly tilt the Slab Blaster back to a vertical position.
STEP 7: Shut off the vehicle, and disconnect the hydraulic hoses. Route the hydraulic
hoses through the quick attach plate hose holder, and reconnect the hydraulic
hoses to the vehicle auxiliary hydraulics.
STEP 8: Lift the Postmaster hammer, and install it in the Slab Blaster hammer location.
STEP 9: Ensure the safety catch is in place. The safety catch prevents the hammer from
sliding out of the Postmaster.
Service
(continued)
Do not tilt or operate the Postmaster/Slab Blaster without
the safety catch in place. The hammer could slide out of
the Postmaster/Slab Blaster and cause serious injury or
death.
w A R N I N G