Comelit MPTZ766A User Manual

Page 32

• INITIALIZE DATA

INITIALIZE DATA

FACTORY DEFAULT

ERASE PROGRAMMED DATA
PRESET FOCUS DEFAULT
EXIT(ESC TO EXIT)

FACTORY DEFAULT

Select “FACTORY DEFAULT” to initialize the Data.

FACTORY DEFAULT

ARE YOU SURE ?

CANCEL
OK

ERASE PROGRAMMED DATA

Erase all stored data from the Flash-ROM of the selected dome camera. You will be asked
to enter ON or OFF. If you desire to erase all data then select “ERASE” run, otherwise press
the ESC key to exit without erasing. The erased data includes all stored data (Auto Scan,
Preset, and Tour….) except origin offset.
The offset value is still valid after all data is erased. The offset value can be zero with default
set of Offset origin menu.

ERASE PROGRAMMED DATA

AUTO SCAN : ON

PRESET : ON
TOUR : ON
ALARM : ON

AREA TITLE : ON
CAMERA : ON
DOME SETUP : ON

ERASE
SAVE AND EXIT(ESC TO CANCEL)

PRESET FOCUS DEFAULT

This menu set the default mode of the focus when you save the Preset.

PRESET FOCUS DEFAULT

FOCUS : AUTO

SAVE AND EXIT(ESC TO CANCEL)

FOCUS

: AUTO / MANUAL / ONE PUSH