Comelit MPTZ766A - Manual (Page 31)

25
• OSD DISPLAY
OSD DISPLAY SETUP
CAMERA TITLE : DOMEID
VIEW DIRECTION : OFF
DOME OSD : ON
AREA TITLE : OFF
PRESET TITLE : CONSTANT
FOCUS EXPOSURE : ON
SAVE AND EXIT(ESC TO CANCEL)
CAMERA TITLE : up to 6 characters.
VIEW DIRECTION : ON / OFF
“ON” sets 0 degree is N(North). “OFF” hides the directional title. Every 90 degrees of
clockwise rotation will change the title to E(East), S(South), W(West).
DOME OSD : ON / OFF
All display or title will disappear when DOME OSD DISPLAY sets OFF.
AREA TITLE : ON / OFF
If this option is enabled, the area title displays when the camera moves.
NOTE: The DOME OSD DISPLAY must be enabled.
PRESET TITLE : CONSTANT / OFF
Set the Preset title display.
FOCUS EXPOSURE : ON / OFF
ON: FOCUS and EXPOSURE displays. (AF AE)
• VIEW ANGLE SETUP
VIEW ANGLE SETUP
FLIP : AUTO
TILT LIMIT : OFF
SAVE AND EXIT(ESC TO CANCEL)
FLIP: OFF, AUTO
OFF: the dome camera moves until 90
°
vertically.
AUTO: When the camera reaches the floor directly above the moving object, it will stop. At
that time, release the Joystick instantly and pull it down again to run the auto-flip function.
When you use the panning range, we recommend using the flip mode to AUTO.
TILT LIMIT:
This option has been designed to limit the view angle as there is some obstruction in
zooming out on specific area of the tilt angle.
ON: When this option is enabled, the range of the tilt angle will be limited to 10 degree.
This can prevent from obstruction or bad focus problem caused by the horizontal line of
the semi sphere in the bubble.
OFF: When this option is disabled, the range of the tilt angle will not be limited.
When you zoom out within the range of the tilt angle, you will see the horizontal line of
the semi sphere in the bubble. And also it would be caused by bad focus problem.