Carter-Hoffmann DF2620-3SS - Manual (Page 5)

5
INSTALLATION (cont’d.)
GROUNDING INSTRUCTIONS
This appliance is equipped with a cord having a grounding
wire with a grounding plug which must be plugged into an
outlet that is properly installed and grounded. In the event of
an electrical short circuit, grounding reduces the risk of elec-
tric shock by providing an escape wire for the electric current.
WARNING—Improper use of the grounding can result in
a risk of electric shock. Consult a qualified electrician or
service agent if the grounding instructions are not completely
understood, or if doubt exists as to whether the appliance is
properly grounded.
If necessary, contact a licensed
electrician to install an appropriate
electrical circuit with correct NEMA
receptacle. See chart on this page.
DO NOT use an extension cord.
Installation procedures must be
performed by a qualified technician
with full knowledge of all applicable
electrical codes. Failure could
result in personal injury and proper-
ty damage.
Damage to unit due to being
connected to the wrong voltage or
phase is NOT covered by warranty.
START-UP
1. Prior to use, thoroughly clean the interior of the unit, ac-
cording to the instructions in this manual.
2. Plug the power cord of the cabinet into a grounded outlet
with a electrical service according to the electrical infor-
mation provided below. Maintain 2” clearance on each
side of the cabinet.
3. Set POWER switch to the “ON” position.
4. Do not load product into the cabinet. Allow the heat to
remove any residual oils which may adhere to inside met-
al surfaces. A slight emission of smoke is common dur-
ing the first few hours of operation.
T he ground prong of the power
cord is part of a system designed to
protect you from electric shock in
the event of internal damage.
DO NOT cut off the large round
ground prong or twist a blade to fit
an existing receptacle.
CAUTION:
Electrical Shock Hazard
Unit is not waterproof, to avoid
electrical shock, keep unit and
counter from being submerged in
water. Do not operate if unit has
been in contact with water.
IMPORTANT:
Power cord is 10' long
IMPORTANT:
Not under warranty
WARNING:
Risk of personal injury
WARNING:
Risk of personal injury
Model Watts Volts Amps NEMA Plug
DF1220-4 1000 120 8.3 5-15P
DF2012-4 1000 120 8.3 5-15P
DF1220-5 1200 120 10.0 5-15P
DF2012-5 1200 120 10.0 5-15P
DF1818-4 1250 120 10.4 5-15P
DF1818-5 1500 120 12.5 5-15P
DF1826-4 1500 120 12.5 5-20P
DF2620-4 1500 120 12.5 5-15P
DF1220-8 1800 120 15.0 5-20P
DF2012-8 1800 120 15.0 5-20P
Model Watts Volts Amps NEMA Plug
DF1826-5 1800 120 15 5-20P
DF2620-5 1800 120 15 5-20P
DF1220-10 2200 208 10.6 L6-20P
DF2012-10 2200 208 10.6 L6-20P
DF1818-8 2250 208 10.8 L6-20P
DF1818-10 2750 208 12.1 L6-20P
DF1826-8 2700 208 13.9 L6-20P
DF2620-8 2700 208 13.9 L6-20P
DF1826-10 3300 208 15.9 L6-20P
DF2620-10 3300 208 15.9 L6-20P
Electrical Specifications
To prevent an electrical shock hazard between the
appliance and other appliances or metal parts in close
vicinity, an equalization-bonding stud is provided. An
equalization bonding lead must be connected to this
stud and the other appliances/metal parts to provide
sufficient protection against potential difference. The
terminal is marked with the following symbol: