Carter-Hoffmann DF2620-3SS - Manual (Page 10)

10
PROGRAMMING INSTRUCTIONS
PROGRAM TIMER (P1 through P6)
1. Press and hold TIME KEY until digital readout flashes.
2. Pres INCREASE KEY to add time. Each time key is
pressed, timer is increased by 1 minute. Hold the key to scroll
faster.
3. Press DECREASE KEY to subtract time. Each time key is
pressed, timer is decreased by 1 minute. Hold the key to scroll
faster.
4. Press TIME KEY to save changes and return to P1.
5. To program timers P2 through P6:
A. Press INCREASE KEY or DECREASE KEY
to select the desired program.
B. Repeat steps 1 through 4 above for each program.
TO CANCEL TIMER
Press and hold TIME KEY for 2 seconds.
TO CHANGE THE TEMPERATURE SCALE
Press the TEMP KEY until the temperature starts flash-
ing. Then, press both the up and down arrow buttons (together) until
‘F’ (Fahrenheit) is displayed.
Press the up or down arrow keys to toggle between ºC and ºF.
Once selected, press the TEMP KEY to save and exit.
Refer to page 6 for names
and locations of compo-
nents and controls.
TEMP setpoint range:
122°F to 225°F.
SETPOINT
TEMPERATURE
(Program Mode)
NOTE: If no key is pressed for 5 seconds, display returns to “P 1”.
Changes will be saved.
TIMER
(Program Mode)
TIMER range:
1 minute to 9 hours, 59 min.
NOTE: Timers cannot be
programmed for less than 1
minute.