Carter-Hoffmann CD27 - Manual

Cleaning, Operating, Maintenance Instructions, Parts List & Warranty
Enclosed Rotary Dish Cart
Model CD27
Cleaning Instructions
N O T E :
This equipment has been designed and
manufactured to meet all applicable
health and safety codes and will give
years of dependable service if used
properly. All cabinets should be thor-
oughly cleaned before using.
Cleansers, detergents,
degreasers, sanitizers
or bleaching agents
that contain chlorides
or phosphates will
cause permanent damage to stainless
steel products. The damage appears as
pits, eruptions, voids, small holes,
cracks, severe discoloration, or dulling
of the metal finish. Water with high
chloride content can also damage
stainless steel. If you are uncertain of
your water quality, we recommend you
have it tested. THIS DAMAGE IS
PERMANENT, COSTLY TO
REPAIR, AND IS NOT COVERED
BY THE WARRANTY.
Be sure the cabinet is unplugged and cool before cleaning. The
heater components should not be exposed to direct contact with
water or cleaning sprays. Permanent damage to the electrical
components will result. THIS DAMAGE IS PERMANENT,
COSTLY TO REPAIR, AND IS NOT COVERED BY THE
WARRANTY.
1. To clean stainless steel surfaces use only cleansers, detergents,
degreasers, or sanitizers that are certified to be chloride-free and phos-
phate-free, and cleansers, or sanitizers only in the recommended con-
centrations. DO NOT exceed recommended concentrations or mixing
ratios. After cleaning and sanitizing, rinse all exposed surfaces thorough-
ly with large amounts of clear water. With a clean cloth, wipe off any
standing liquid or residue from all horizontal surfaces, in corners, or near
edges.
2. If applicable, vinyl trim or laminate should be washed with a chlorine-free
detergent and water. Rinse thoroughly with clear water and allow to dry.
Never use abrasive cleaners, waxes, car polish or substances containing
strong aromatic solvents or alcohol. Caution: When using solvents, it is
essential that proper precautionary measures be observed. Refer to
solvent manufacturer’s instructions. Use of direct steam and/or hot
water cleaning at temperatures above 190
o F may result in “bubbling” or
loosening of the vinyl adhesive.
R E C O M M E N D E D T I P S F O R C L E A N I N G S T A I N L E S S S T E E L
P u r p o s e F r e q u e n c y C l e a n i n g A g e n t M e t h o d o f A p p l i c a t i o n
Routine Daily Soap, ammonia detergent Sponge with cloth, rinse with clear water and wipe dry.
cleaning and water
Smears/ As Needed Stainless steel cleaner Rub with cloth as directed on package. Rub in direction of grain
finger prints or similar products of stainless steel. Do not use on vinyl trim or adhesive labels.
Stubborn Daily Any chloride-free Apply with damp sponge or cloth. Rub in direction of polish
spots and As Needed or phosphate-free lines. Rinse thoroughly after use, especially if cleaner contains
stains cleaner chlorine bleach. Do not use on vinyl trim or adhesive labels.
Hard water Daily Vinegar Swab with cloth. Rinse with water and wipe dry.
spots As Needed
DO NOT use steel
wool pads - ferrous
deposits will cause
rusting.
CAUTION
CAUTION
WARNING