Carbolite 3216CC Controller - Manual (Page 13)

Operating
13 LMC20-GB
6 Running a Timer
Run. This starts the timer.
Hold. This stops the timer at the elapsed time. It will start again from the elapsed time when
Run is selected again.
Reset. This sets the timer back to zero. It can be run again from this state.
End cannot be set
– it occurs automatically when the timer has counted down to zero.
Acknowledge any timer after a timer has timed out using ACK function (see section 2.2) by
pressing the
simultaneously.
6.1 Dwell Timer
Operation Action Indication
To RUN Timer Press and quickly
release
 + 
Indicator – RUN = On
Scrolling Display – Timer Running
To HOLD timer Press and quickly
release
 + 
Indicator
– RUN = Flashing
Scrolling Display
– Timer Hold
To switch off
Timer / Cancel Press and Hold
 + 
for more than 1
second
Indicator – RUN = Off
Scrolling Display – None
Static Text -
OFF
To return to home
after reset Press and Hold
 + 
for more than 1
second
Indicator
– RUN = Off
Display – A-M < LOOP MODE- AUTO
MANUAL OFF>
Use the Up

Down
 to select aUTO
Timer Ended Indicator
– RUN = Off
Scrolling Text
– Timer End
Static Text - OFF
To re-RUN Timer Press and quickly
release
 + 
Indicator
– RUN = On
Scrolling Display
– Timer Running
To RESET timer
and return to home
menu after timer
end Press and quickly
release
Ack

Indicator
– RUN = Off
Scrolling Display - None
Press and Hold
 + 
for more than 1
second
Indicator – RUN = Off
Display – A-M < LOOP MODE- AUTO
MANUAL OFF>
Use the Up

Down
 to select aUTO
Power Failure While Using Dwell Timer
If there is a power failure while the timer is running and the power is subsequently restored
the timer will reset and the static text will display “OFF“ until the
 + keys are pressed to
re-run the timer.