Carbolite VST Series - Manual (Page 15)

HST, VST
MF13 – 3.40
15
8.0 F USES & P OWER S ETTINGS
8.1 Fuses
F1-F3: Refer to the circuit diagrams.
F1
Internal
supply
fuses Fitted if supply cable fitted.
Fitted on board to some types of EMC filter. on-board and up to 16 Amps:
32mm x 6mm type F
other: GEC Safeclip
F2
Auxiliary
circuit
fuses Fitted on board to some types of EMC filter.
May be omitted up to 25Amp/phase supply
rating. 2 Amps glass type F
On board: 20mm x 5mm
Other: 32mm x 6mm
F3
Heat Light
fuses May be omitted up to 25 Amp/phase supply
rating. 2 Amps glass type F
32mm x 6mm
Customer
fuses Required if no supply cable fitted.
Recommended if cable fitted. See rating label for amperage;
see table below for fuse rating.
Model
phases Volts Supply Fuse
Rating Volts Supply Fuse
Rating
HST & VST 12/200 1-phase 200-240 5A 110-120 10A
HST & VST 12/300 1-phase 200-240 10A 110-120 15-16A
HST & VST 12/400 1-phase 200-240 10A 110-120 20A
HST & VST 12/500 1-phase 200-240 12.5A 110-120 25A
HST & VST 12/500 3-phase + N 380/220-415/240 5A
HST & VST 12/500 3-phase delta 200-240 10A
HST & VST 12/600 1-phase 200-240 15-16A **
HST & VST 12/600 3-phase + N 380/220-415/240 5A
HST & VST 12/600 3-phase delta 200-240 10A
HST & VST 12/900 1-phase 200-240 25A
HST & VST 12/900 3-phase + N 380/220-415/240 10A
HST & VST 12/900 3-phase delta 220-240 15A
Other models or voltages: check the rating label for details of the supply.
Before March 2001 – please check with Carbolite if in doubt
8.2 Power Settings
The standard power limit settings (parameter OP.Hi ) are as follows:
Volts:
HST or VST 12/-- 100V
200V
208V 110V
220V
380V
230V
400V 120V
240V
415V 127V
254V
440V
before March 2001 – all models 100 100 100 100 100 89
from March 2001 ** 100 100 89 82 75 67
See section 3.6 for further detail.
** Exceptions: models with 240V elements may be supplied in the following circumstances; they
have power settings of 100%.
- furnaces without controls
- model /600 for use on a UK 13A supply