Online manual not for resale purposes, All reset, Reset – BLITZ SBC i-D III User Manual

Page 9

DATA

AC / WG

- SBC I-D is capable of displaying up to 3

- AC - Actuator Type Wastegate

DATA

different optional displays Capable of

WG External Type Wastegate

DATA

different optional displays. Capable of

- WG - External Type Wastegate

displaying electronic outputs from

- Refer to Page 3 and 4 for different types of wastegate

INPUT LINE

1 the ECU such as temperature, voltage,

- To set, press MENU and go to Main Menu. Scroll to AC / WG,

LOW [ V ]

0.0 pressure, TPS, A/F, and etc.

press enter and scroll to select. Press enter to set.

FIT

0.00 - Optional harness is needed to display

HIGH [ V ]

5.0 this feature.

UNIT

HIGH [ V ]

5.0 this feature.

UNIT

FIT

1.00

- SBC I-D has the ability to display 4 different types of boost pressure

UNIT

kg/cm

-76 cmHG ~ 2.50 kg/cm

kpa

-76 cmHG ~ 2.45x100 kpa

DATA

* To set up A/F, set up DATA

BAR

-30 inHG ~ 2.45 BAR

chart as shown below.

PSI

-30 inHG ~ 35.5 PSI

INPUT LINE

To set press MENU and go to Main Menu Scroll to Unit and

INPUT LINE

- To set, press MENU and go to Main Menu. Scroll to Unit and

LOW [ V ]

0.0

LOW [ V ]

0.00

press enter. Scroll left or right to select Unit, press enter to set.

FIT

0.00

FIT

0.00

HIGH [ V ]

12.0

HIGH [ V ]

16.0

CONTRAST

FIT

200

FIT

16.0

- To set, press MENU and go to Main Menu. Scroll to CONTRAST

UNIT

VOLT

and press enter. Scroll to adjust, press enter to set.

, p

DATA

BRIGHT

- To set, press MENU and go to Main Menu. Scroll to BRIGHT

INPUT LINE

3 Important

and press enter. Scroll to adjust, press enter to set.

LOW [ V ]

0.0 - Addition instructions are included in the

FIT

0 00

SBC I-D optional harness

RESET

FIT

0.00 SBC I-D optional harness.

RESET

HIGH [ V ]

16.0

FIT

UNIT

Volt

ALL
RESET

AUTO PEAK

Auto Peak ON -

Will automatically reset Peak Hold. Peak will
reset only when throttle is release after the vehicle

-> EXECUTE

has been in boost for more then 2 seconds.

CANCEL

Auto Peak OFF - Peak Hold will retain the highest boost level

achieved.

1 Press MENU button, scroll down to RESET and press

RESET

achieved.

1 Press MENU button, scroll down to RESET and press

- To set Auto Peak, Press MENU and go to Main Menu. Scroll to

enter to select.

Auto Peak, press enter and scroll to select. Press enter to set.

2 To select function, scroll down and press enter.

- To reset Peak hold, press both REC/STOP and MENU button at once.

NOTE: It is recommended to reset the boost controller
if the unit is not functioning properly.

Page 9

Online Manual Not For Resale Purposes