Online manual not for resale purposes – BLITZ SBC i-D III User Manual

Page 3

INSTALLATION OF VALVE UNIT

Cars equipped with stock solenoid valve

Actuator type

Locate the T between the turbo, actuator, and stock solenoid. Remove
and cape off the stock solenoid valve and connect the turbo and actuator

Cut or remove stock hose between turbo compressor and actuator.

to the Blitz supplied valve unit.

Use connector to connect hose from valve unit to turbo compressor.
Use hose clamp to hold hose and connector together.

Use hose connector to connect hose from valve unit to actuator.

Diagram 3

Use hose clamps to hold hose and connector together.

Diagram 1

DUAL PORT ACTUATOR TURBO

Cut hose between stock solenoid and dual port actuator. Cap both
ends of the hoses. Cut hose between actuator and turbo and follow
instructions on Diagram 1.

Diagram 4

Diagram 2

CAUTION
Do not T - off any of these pressure hoses.

Page 3

Online Manual Not For Resale Purposes