Online manual not for resale purposes – BLITZ SBC i-D III User Manual

Page 2

SBC-ID Installation

Use caution on Installation

Be aware to make sure that the installation on valve unit is correct
on in and out ports.

Check for pressure leaks in hoses.

Cut hoses straight down and not in an angle.

Check and make sure that hoses are clamped tight for no leakage.

Keep the rubber hoses away from heat sources such as the
exhaust manifold and etc.

Keep the valve unit and hoses away from moving parts.

g p

Some vehicles may need a boost and fuel cut device.

Installation of valve unit

Keep the valve unit away from
hot components but keep within

hot components but keep within
three feet from the turbo.

CAUTION: more than three feet
away from the turbo can cause
bad response with boost surge
or boost spike.

Use hose enlargement adapter to

Use hose enlargement adapter to
connect hose to valve unit and use
hose clamp to prevent leakage.

Connect main wiring harness to
valve unit.

Connect main wiring harness to controller.

Connect display to controller.

WARNING: keep hands away from hot engine components. Install
when entire engine bay has cooled. Turbo may still be hot even after
engine has cooled.

Page 2

Online Manual Not For Resale Purposes