Online manual not for resale purposes – BLITZ SBC i-D III User Manual

Page 8

SPEED MAP

DISPLAY MENU

- The Speed Map allows the user to set boost pressure according

- SBC I-D has the ability to display different options. It has the

speed of the vehicle

ability to display 6 different options (Boost OPTN 1~2 DATA 1~3)

speed of the vehicle.

ability to display 6 different options (Boost, OPTN 1~2, DATA 1~3).

- The Speed Map option will only work if the Blitz Power Meter I-D

Each option also can be display is both graphical and digital

is hooked up, otherwise the SBC I-D display will show

form. Power Meter I-D and option SBC I-D harness is needed

NO CONNECT.

to display other 5 options (OPTN 1~2, DATA 1~3).

SBC I-D WITHOUT

SBC I-D WITH

DISPLAY MENU

M t

I D

M t

I D

Power Meter I-D

SPEED MAP

BOOST

DIGITAL

BOOST

Boost in digital display

MPH

GRAPH

BOOST

Boost in graph display

CH 1 III

OPTN1

DIGITAL

OPTN 1

Option 1 in digital display

NO CONNECT.

CH 2 III

GRAPH

OPTN 1

Option 1 in graph display

CH 3 III

OPTN2

DIGITAL

OPTN 2

Option 2 in digital display

CH 3 III

OPTN2

DIGITAL

OPTN 2

Option 2 in digital display

CH 4 IIII

GRAPH

OPTN 2

Option 2 in graph display

OFF . . . . IIII

0 100 200

DISPLAY MENU

Note: For Speed Map to display MPH settings, you must change

DATA 1

DIGITAL

DATA 1

DATA 1 in digital display

SBC I D Unit setting to PSI

GRAPH

DATA 1

DATA 1 in graph display

SBC I-D Unit setting to PSI.

GRAPH

DATA 1

DATA 1 in graph display

Explanation of Speed Map Diagram

DATA 2

DIGITAL

DATA 2

DATA 2 in digital display

- The Diagram above shows that the vehicle from 0-50 mph

GRAPH

DATA 2

DATA 2 in graph display

will be in Channel 1, then the boost controller will automatically

DATA 3

DIGITAL

DATA 3

DATA 3 in digital display

change to Channel 2 from 50-75 mph and continue on until it

GRAPH

DATA 3

DATA 3 in graph display

reaches Channel 4.

- Speed Map can also work with 2 Channels, not all 4 Channels

have to be used. To turn off Speed Map set all tabs to off

NOTE: If Power Meter I-D is connected, both OPTNs in Display

positions located under Channel 4.

Menu will change. OPTN 1 will be replace by SPEED, and OPNT2
will be replace by POWER.

How to Set Speed Map

1 Set up Boost Channels as desired.

DISPLAY MENU

SBC I-D with

1 Set up Boost Channels as desired.

DISPLAY MENU

SBC I-D with

2 Go to Speed Map option located in Main Menu.

Power Meter I-D

3 Press enter to set, scroll left or right and set tabs

BOOST

DIGITAL

according to your desire. Press enter to set.

GRAPH

Repeat until Speed Map is set.

SPEED

DIGITAL

Important: Speed Map will be activated once any tabs are

GRAPH

set Make sure all tabs are set on the off position is Speed

POWER

DIGITAL

set. Make sure all tabs are set on the off position is Speed

POWER

DIGITAL

Map is not used.

GRAPH

Page 8

Online Manual Not For Resale Purposes