BKI COq Convection Oven - Manual (Page 28)

Convection Oven Component Replacement
26
Component Replacement
Light Bulb
1. Disconnect the oven power supply by turning OFF the
circuit breaker in the power supply service panel.
2. Remove appropriate side panel from oven.
3. Identify lampholder with failed light bulb.
4. Loosen but do not remove the lampholder mounting
screw closest to the center frame of the oven. While
holding the lampholder remove the other mounting
screw.
5. Move the lampholder to the side away from the
remaining mounting screw then pull the lampholder
away from the oven.
6. Unscrew the failed light bulb from inside of the
lampholder and replace with a new bulb.
7. Reinstall the lampholder on oven then replace side
panel.
8. Turn the power supply to the oven ON.
Fuse Replacement
1. Disconnect the oven power supply by
turning OFF the circuit breaker in the
power supply service panel.
2. Remove the side panel from the
control side of the oven.
3. Remove the fuse from the fuseholder
by inserting a 1/8” [3 mm] flat
screwdriver into the slot in the
fuseholder cap. While pushing in turn
the screwdriver approximately ¼ turn
counterclockwise. Remove the
screwdriver The fuse and cap can be
pulled out of the fuseholder.
4. Check the fuse for continuity with an
Ohm meter.
5. If the fuse is blown, locate and correct
the cause of the fuse failure before
replacing the fuse.
6. Replace blown fuse with the factory
specified fuse only. Contact the BKI
Technical Service Department for the
correct fuse.
7. Reinstall the fuse in the fuseholder by
reversing the procedure in step 2.
8. Reattach the side panel to the oven
and turn the power supply to the oven ON.