BKI COq Convection Oven - Manual (Page 14)

Convection Oven Operation
12
CP0058 Color TOUCH Tec Controller Operation
Features
The Color TOUCHTec Controller has the following configurable features that will need to be properly set when
installing a replacement controller. These settings can be entered individually through the configuration screens on
the controller or downloaded from a USB drive.
Temperature Display Units are configurable for Fahrenheit or Celsius.
Operation Language is configurable for English or Spanish.
Audible Alarm Pattern is configurable for Short or Long patterns. This function is helpful to distinguish between
controllers when two controllers are used on the same appliance.
View Recipe is configurable ON or OFF. When ON, a button is displayed on the Cook Recipe screen that will allow
the user to view the settings of the highlighted Recipe.
Power Monitor calculates the energy consumption of the appliance over the elapsed time displayed. This function
can be reset to zero by the user. The energy consumption values for this appliance’s components must be
entered into the controller.
USB Drive can be used to upload or download controller configurations and recipes.
Intuitive Cook Factor is configurable for OFF or values 5-15 in 0.5 increments. If Intuitive Cook is enabled the
Factor determines the amount of cook time compensation.
Control Hysteresis is configurable from 1°F to 10°F by 1°F increments. Hysteresis is the differential between the
temperature the controller turns the heaters off and the temperature it turns the heaters on again.
Extra Time increment value is configurable to 1 minute or 5 minutes.
Cook Temperature Offset is configurable between -50°F and +50°F in 1°F increments. The actual oven cavity
temperature will vary from the programmed temperature by this offset amount.
Door Open Alarm is configurable ON or OFF. When ON, the controller alarms if the oven cavity temperature drops
25°F indicating the door has been left open.
Adjustable Idle Shutdown is configurable for OFF or 10, 20 or 30 minute delay. When enabled, this function will
shut the oven off if it has been preheated and cook is not initiated before the preset time interval has elapsed.
(2) RTD Temperature Probe Inputs configurable to OFF or to monitor oven Cook Temperature or internal Product
Temperature. One input must be configured to monitor oven Cook Temperature. Use of the internal Product
Temperature probe is optional.
(2) Remote Switch Inputs configurable to OFF or to End cycle or add Extra Time when a momentary switch input is
received. Both inputs can be configured OFF.
(2) Relay & (1) Solid State Outputs configurable to OFF or for Heat, Fan Power, Lamp or Fan Speed control.