BASELINE Tire Changer - Manual (Page 22)

18 • Important: Always read and follow operating instructions.
Installation Instructions
CAUTION
Proper unit installation is necessary for safe
use and efficient operation. Proper installa-
tion also helps protect the unit from dam-
age and makes service easier. Always place
safety poster and instructions near the unit.
Location
Select a location using the drawings below. The area
should provide the operator with enough space to use
the equipment in a safe manner. The area selected
should be well lit, easy to clean and should be away
from oil, grease, brake lathe chips, etc. Avoid areas
where bystanders and customers may be present.
Workspace Requirements
Tower Installation
CAUTION
STAY CLEAR OF MOVING PARTS when
reconnecting the unit to the air supply. The
position of control valves may have changed
during the servicing of the machine.
CAUTION
Be careful of pinch point at swing arm spring.
Tools Required:
Screw Driver
14mm Open-ended Wrench
19mm Open-ended Wrench
24mm Open-ended Wrench
1. Carefully remove carton and packaging from unit.
2. Using a 14mm wrench, remove shipping bolts
holding tower, swing arm and chassis to the pallet.
3. Using a 19mm wrench, remove the four bolts
and washers from the chassis; reserving the bolts and
washers.
4. With the aid of a helper holding the tower, connect
hose from chassis to tower barb fitting (figure 26). Posi-
tion and tighten hose clamp.
5. Use reserved bolts and washers to attach tower to
chassis (figure 26). Torque to 15 - 20 ft. lbs.
Figure 26 - Assemble tower onto chassis.
50"
41.5"
Use Reserved
Bolts & Washers
Connect Hose To
Tower Fitting