BASELINE Lift BL412 - Manual (Page 3)

3
Your new lift will provide years of dependable service if installed, operated and maintained
properly. Read and follow all safety, installation, operation, and maintenance instructions in
this manual before installing and operating the lift. In addition, read and follow all safety and
other information included on and with the lift before operating the lift. Keep this manual in a
secure place for future reference, training and service part identification.
TABLE of CONTENTS
1. Unloading Procedure & Lift Package Contents page 4
2. Important Safety Instructions page 5
3. General Requirements & Lift Specifications page 7
4. Tools Required & Pre Installation Procedures page 8
5. Installation Procedures page 10
6. Operating Instructions & Lift Maintenance page 15
7. Troubleshooting page 21
8. Lift Installation Diagrams & Parts Lists page 24
IMPORTANT: It is the shop owner's responsibility to provide a satisfactory installation
area for the lift. Lifts should only be installed indoors on level concrete floors with a
minimum of 4 inches (102mm) and 3000 psi (20.7MPa) concrete that has been aged a
minimum of 30 days. Please consult a qualified individual if any doubt exists concerning
proper installation and subsequent safe operation of the lift. Do not install the lift on asphalt
or outdoors.
Prior to installation, it is the shop owner's responsibility to provide constant electrical power
in the correct voltage, phase, etc., and all wiring for electrical hook-up of the lift. The shop
owner must insure that the electrical installation conforms to local building and safety codes.
Where required, the shop owner will provide an electrical isolation switch located in close
proximity to the lift. This switch will have an emergency stop capability and isolate electrical
power from the lift for servicing requirements.
Hydraulic oil cannot be shipped with the lift and will be supplied by either the shop owner or
the installer. ISO 32 hydraulic oil (10W non detergent hydraulic oil) must be used to fill the
reservoir tank before operating the lift.
It is the shop owner's responsibility to train all operators in
lift operation and safety.