BASELINE Lift BL412 User Manual
Page 18
18
MAINTENANCE INSTRUCTIONS
Maintenance is to be performed by factory trained lift service personnel only.
The following is a minimum maintenance schedule:
DAILY:
Raise and lower the lift
(with no vehicle)
at the beginning of each shift to verify the runways
are level, safety locks are engaging, and the lift is operating properly.
Check all hydraulic fittings and lines for damage and leaks. Check electrical wiring for
damage.
Check all moving parts for uneven or excessive wear. Repair or replace all damaged, worn,
or broken components immediately.
Clean all debris from the base frame area
Remove oil/grease on runways and rolling jack lift pads.
WEEKLY:
Check hydraulic fluid in reservoir and top up if required.
Check cables, cable pulleys and lifting cylinder.
MONTHLY:
Check that all anchor bolts are torqued to minimum 75 ft-lbs (102Nm).
Clean and lubricate moving parts.
EVERY YEAR:
Have a certified lift technician inspect and certify all aspects of the lift.
HDRAULIC OIL:
Change and replace hydraulic oil in every minimum two years.
LUBRICATION:
Refer diagram #10 for lubrication points.
Where grease is required use a multi-purpose lithium grease.
Where lubricating oil is required use a SAE 30 oil.
Where hydraulic oil is required use ISO 32 hydraulic oil (10W non detergent).