Barranca Diamond MK-145 Tile Saw - Manual (Page 9)

9
MK-145 SAFETY
To avoid the possibility of the appliance plug or receptacle getting
wet, position the machine to one side of a wall mounted receptacle.
This will prevent water from dripping onto the receptacle or plug.
A “drip loop,” shown in the picture below, should be arranged by
the user to properly position the power cord relative to the power
source.
The “drip loop” is that part of the cord below the level of the
receptacle, or the connector, if an extension cord is used. This
method of positioning the cord prevents the travel of water along the power cord and coming in
contact with the receptacle.
If the plug or receptacle gets wet, DO NOT unplug the cord. Disconnect the fuse or circuit breaker
that supplies power to the tool. Then unplug and examine for presence of water in the receptacle.
Use only extension cords that are intended for outdoor use. These extension cords are
identified by a marking “Acceptable for use with outdoor appliances; store indoors while
not in use.” Use only extension cords having an electrical rating not less than the rating of
the product. Do not use damaged extension cords. Examine extension cords before using
and replace if damaged. Do not abuse extension cords and do not yank on any cord to
disconnect. Keep cords away from heat and sharp edges. Always disconnect the extension
cord from the receptacle before disconnecting the product from the extension cord.
To reduce the risk of electrocution, keep all connections dry and off the ground. Do not
touch the plug with wet hands. Use of under sized extension cords result in low voltage to
the motor that can result in motor burnout and premature failure. MK Diamond warns that
equipment returned to us showing signs of being run in a low voltage condition, through
the use of undersized extension cords will be repaired or replaced totally at the customer’s
expense. There will be no warranty claim.
To choose the proper extension cord,
• Locate the length of extension cord needed in the table below.
• Once the proper length is found, move down the column to obtain the correct AWG
size required for that length of extension cord.
Drip loop information
WARNING
WARNING
WARNING
eXTeNSiON CORD MiNiMUM GaGe FOR leNGTH
VOlTS TOTal leNGTH OF CORD iN FeeT
25 ft. awG 50 ft. awG 75-100 ft. awG
115V 12 10 8
230V 14 14 12