Barranca Diamond MK-145 Tile Saw - Manual (Page 22)

22
MK-145 MAINTENANCE
Diamond Blade Change-Out:
(A)
Unplug the MK-145 from
the power source and
unplug the MK-145 from
the GCFI
(B)
Hold the Diamond Blade
still, rotate the Blade Wrench
counter-clockwise to loosen
and remove the Retaining Nut
and Outer Flange
(C)
Remove the Blade out from
between the Table Blade
Slot from below
(D)
Orient the Blade to the
Gear Shaft with the
Directional Arrow facing
out and install the Blade
through the Table Blade
Slot from below
(G)
Hold the Diamond Blade
still and rotate the Blade
Wrench clockwise to
tighten – DO NOT OVER
TIGHTEN
(H)
Insert the three (3) Cover
Retaining Tabs into
the three (3) Cover
Alignment Slots and seat
the Water Basin Cover on
the MK-145
(E)
Verify the Blade is seated
on the Gear Shaft and verify
Blade Directional Arrow
matches the Directional Arrow
on the Blade Guard
(F)
Install the Plastic Outer
Flange onto the Gear Shaft
and install the Retaining Nut
onto the Gear Shaft
NOTe: Do not cross-thread the
Retaining Nut during
installation