Barranca Diamond MK-145 Tile Saw - Manual (Page 14)

14
MK-145 ASSEMBLY
Adjustable Cutting Guide Installation:
NOTeS: 1. The Adjustable Cutting Guide can be used on either side of the Diamond Blade.
2. Step A may be skipped if the Adjustable Cutting Guide is installed.
Table Stop Installation:
(G)
Hold the Diamond Blade
still and rotate the Blade
Wrench clockwise to tighten
- DO NOT OVeR TiGHTeN
(H)
Insert the three (3) Cover
Retaining Tabs into the three
(3) Cover Alignment Slots and
seat the Water Basin Cover on
the MK-145
(A)
Fit the Retaining Tabs of
the Adjustable Cutting
Guide to the Grooves of
the MK-145 and slide the
Adjustable Cutting Guide
onto the MK-145
(B)
Install the two Retaining
Knobs into either side
of the Adjustable
Cutting Guide
(A)
Rotate the MK-145 onto
the back end and locate
the Table Stop Retaining
Slots
(B)
Install the Table Stop into
the MK-145 Retaining
Slots
(C)
Place the MK-145 onto the
workbench and position
the Table Stop against the
side of the work bench