Barranca Diamond MK-145 Tile Saw - Manual (Page 19)

19
Cutting 22.5 and 45 Degree Angles:
DO NOT FORCE TOOL, it will do the job better and safer at the rate for which it
was designed.
NOTe: Placing the Adjustable Cutting Guide against the edge of the tile will provide added support
during the cut, and, will reduce the chance of being injured by sharp edges and chips.
MK-145 OPERATION
(A)
Pull out the two (2) Cover
Stays located on the bottom
of the Water Basin Cover
(B)
22.5 Degree Cutting:
Place the Cover Stays into the
two (2) 22.5-degree Angle Slots
(lower slots) located inside the
Water Basin then go to Step D
(C)
45 Degree Cutting:
Place the Cover Stays into the
two (2) 45-degree Angle Slots
(upper slots) located inside the
Water Basin then go to Step D
(D)
Place the tile onto the raised
Cutting Table with the glazed
side down and verify the tile is
resting against the Tile Support
Groove of the Cutting table
(G)
Turn ON the MK-145 and
verify cooling water flow
around Blade Guard
(E)
Loosen the two (2) Retaining
Knobs and position the
Adjustable Cutting Guide
against the edge of the tile then
retighten the Retaining Knobs
(H)
Feed the tile into the Diamond Blade
with a steady even pressure (forcing
the tile will cause the blade to slow
which could cause motor overheating)
(F)
Set Blade Guard above the
top of the tile
(I)
Turn saw OFF when
cutting is complete
CAUTION