Caution – Barranca Diamond BX-4 BRICK SAW WITH OR WITHOUT MISTING DUST CONTROL User Manual

Page 33

BX-4

OPERATION:
Pump, tubes, fittings & nozzles are pre-installed & inspected
at factory. Set-up cutting with dust suppression system
is accomplished by filling up Water Tank, Closing Cap, &
pushing Tube into Push-to-Connect Coupling (6).

Step A: Fill up water tank with fresh clean water. Push

3/8” x 1/4” tube (1) thru grommet & into a 1/2” x 3/8” x
1-1/2” tube (2). Push (2) into a plastic filter.

Step B: Drop filter into the water tank. Ensure the filter is

sitting on the bottom of the tank.

Step C: Screw cap (5) onto the water tank.

Step D: Push other end of tube into push-to-connect

coupling (6).

NOTE: A full tank of water will last about 2-1/2 hours at
continous operation.

Step E: Push pump switch (7) to “ON” position.

NOTE: I - ON , O - OFF

Step F: Depress trigger switch to start motor & misting

pump. Mist should be seen within 5 seconds.

MISTING SYSTEM OPERATION, MAINTENANCE & TROUBLESHOOTING

Do Not Run Pump Dry.

Pump damage may result if adequate water flow is not

present.

CAUTION

2 1