Barranca Diamond BX-4 BRICK SAW WITH OR WITHOUT MISTING DUST CONTROL - Manual (Page 13)

BX-4 13
UNPACKING, TRANSPORT & ASSEMBLY
2. DIAMOND BLADE INSTALLATION:
• Identify Motor Shaft, Retaining Screw (1) and Outer
Flange (2).
• Hold Shaft Wrench (3) stationary. Rotate Blade
Wrench (4) counter-clockwise. Remove Retaining
Screw and Outer Flange.
• Seat Blade (5) on Inner Flange (6). Verify rotation
direction of blade.
• Hold Shaft Wrench (3) stationary. Rotate Blade
Wrench (4) clockwise. Install Retaining Screw (8)
and Outer Flange (7) & tighten.
NOTE
When installing the Retaining Screw, do not “cross-thread”
and DO NOT over tighten the screw.
2
Motor
Shaft
1
3
6
3
4
5
8
7
4