Barranca Diamond BX-4 BRICK SAW WITH OR WITHOUT MISTING DUST CONTROL - Manual (Page 16)

BX-4 16
PRE-START INSPECTION:
• Inspect Motor Air Filter (1) condition if required, shake
or tap to remove excess debris. (See Cleanup Page 23)
• Verify that the Trigger Switch (2) on the underside
of the handle is unlocked. Depress release button (3)
to unlock trigger.
• Plug the Ground Fault Circuit Interrupter (GFCI) into the
BX-4.
• Plug the GFCI into a power source.
If an extension cord is used, first verify it meets the re-
quirements of TABLE 1 (page 8). Plug the BX-4 into the
extension cord; plug the extension cord into a Ground
Fault Circuit Interrupter (GFCI). Finally, plug the GFCI
into the power source in that order.
SETUP, ADJUSTMENT & OPERATION
2
CAUTION
1
3