Autoquip AUTO-TILT PORTABLE TILTER - Manual (Page 18)

18
Be familiar with this entire operator’s manual before operating this equipment.
LOADING TILTER
1. Operate this tilter only on a firm, flat surface.
2. Position the tilter under the item to be tilted and lock the floor lock. Center the load
on the tilter.
3. Load the tilter uniformly and make sure the load is centered on the tilter.
4. Make sure the load is resting against the back of the tilt platform.
TILTING THE PLATFORM
1. Before raising or lowering the tilter, make sure that all obstacles and people are
clear of the unit and that the floor lock is in the locked position.
2. To raise the platform, move the lever to the “UP” position and hold until the platform
reaches the desired height.
3. To lower the platform, move the lever in the “DOWN” position and hold until the
platform reaches the desired height.
4. If the tilter does not work, see the “Troubleshooting” section in this manual.
WARNING!
To avoid injury, do not move the tilter with a load in the tilted
position. The tilter may be unstable causing the unit to tip.
OPERATING INSTRUCTIONS