Autoquip AUTO-TILT PORTABLE TILTER - Manual (Page 13)

13
1. Remove all load from the platform. Never block the lift when loaded.
2. Raise the tilter by moving the lever in the “UP” direction.
3. The maintenance leg is stored in a socket on the base. Place the end of the
maintenance leg in the socket of the base of the tilter.
4. Begin lowering the tilter by moving the lever in the “DOWN” direction while guiding
the leg so that the socket on the back of the platform comes down over the top of the
maintenance leg.
5. Continue to keep the lever in the “DOWN” position for five to ten seconds after the
maintenance leg contacts the platform to relieve the hydraulic pressure in the
cylinder.
6. Check to be certain that the maintenance leg is securely in the socket on the platform
and the socket on the base.
DANGER !
To avoid personal injury, NEVER go under the platform until the load is
removed and the lift is securely blocked.
7. To remove the maintenance leg, raise the tilter by moving the lever in the “UP”
direction to provide sufficient clearance for the removal of the maintenance leg.
Remove and return the maintenance leg to its storage location on the tilter base.
BLOCKING INSTRUCTIONS