Autoquip AUTO-TILT PORTABLE TILTER - Manual (Page 15)

15
OIL
The Auto-Tilt is shipped with oil in the power unit. There is no need to fill it.
STANDARD DC UNIT
WARNING!
Read and understand all of the instructions carefully before
proceeding with the installation process.
1. The area where the Auto-Tilt is to be used must be level, solid, and smooth. The
unit should roll around freely without obstruction.
DANGER !
To avoid personal injury, NEVER use the unit in or around water or
where flammable gasses may be present.
2. Remove the material the tilter was shipped in. Remove the banding and the pallet
from under the unit.
3. Connect the red positive battery cable. It may be necessary to charge the battery
before the tilter can be used. If the unit was purchased with the optional battery
charger, it may be placed next to the battery.
4. Test the operation of the tilter by moving the lever in the “UP” position. Then move
the lever to the “DOWN” position to lower the platform. If the tilter does not work,
see the “Troubleshooting” section in this manual.
WARNING!
All warning and information decals should be in place as outlined in
the “Label Identification” section. If decals are missing or damaged,
they should be replaced with new ones. Contact Autoquip for
replacements.
INSTALLATION INSTRUCTIONS