Autoquip AUTO-TILT PORTABLE TILTER - Manual (Page 12)

12
Model Capacity Tilt Angle Fork
Length
Height Weight Raise
Time
STR 89-20 2000 lbs 89 degrees 42” 33 _” 675 lbs 20 sec
STR 89-40 4000 lbs 89 degrees 42” 33 _” 675 lbs 20 sec
LOAD CAPACITY
The load capacity rating is stamped on a metal plate attached to the tilter. This figure is
a net capacity rating for a tilter furnished with the standard platform. The relief valve of
the pumping unit has been set to raise the weight, plus a small amount for overload.
Tilters should not be overloaded beyond the established capacity as damage
and/or personal injury may result.
UNBALANCED LOADING
The stabilization provided is basically for balanced loads. If special attachments extend
beyond the length and/or width dimensions of the platform, the capacity would be
reduced.
PUMP PRESSURE (AC AND AIR/OIL POWER UNITS)
This lift incorporates a positive displacement pump machined to a high degree of
accuracy and specially adapted to requirements of higher-pressure ranges over that of
a standard pump. Therefore, standard factory models of the same manufacture cannot
replace it.
The pump can operate efficiently at intermittent pressures up to 3200 PSI and
continuous duty to 2500 PSI. The safety relief valve in the power unit is factory-set to
stay within the parameters of the pump and lift requirements.
PNEUMATIC
• Internal air power unit
• Minimum working pressure 80 psi @ 110 cfm
SPECIFICATIONS