Autoquip SERIES 35 POWERED TURNTABLE - Manual (Page 14)

14
WARNING!
The turntable base MUST be attached securely to the lift platform before
operating the turntable.
6.
If the combination is installed in a pit, see the “Pit Installation” instructions in this
section.
NOTE: Turntables that have platform sizes larger than the lifts to which they are
attached must have toe protection, such as beveled-toe guards
7.
To ensure that the turntable is positioned exactly over the opening in the floor
before it is lowered, a position switch is mounted and wired to the turntable base.
8.
Lower the combination into the pit and check for proper combined height.
9.
Make the permanent electrical connections and operate the combination through
a few cycles, ensuring that the lift will not lower if the turntable platform is not in
the proper position (for four-sided platform).
CLEAN UP
1.
Clean up any debris from the area. A clean installation makes a good impression
and creates a much safer environment!
2.
Touch-up paint is available from Autoquip for repair of damaged paint surfaces.
WARNING!
All DANGER, WARNING, and CAUTION labels and informational decals and
plates must be intact and in place on the turntable. Contact an Autoquip
representative if labels are missing or damaged. See “DANGERS,
WARNINGS, and CAUTIONS” section of this manual
.
INSTALLATION INSTRUCTIONS